4) You will need to have on hand toilet tape, small gas torch, solder, flux, plumbing sandpaper, pipe cutter, gas tape (to seal gas line) and maybe some pipe glue. Ask the sales person at the hardware store for a more defined list.
Use the sandpaper to remove any loose particles from the hole. It is important for the surface to be properly prepared for these types of gutter water line repair.
One other common design that is considered "washerless" was made famous by Delta and copied by several other makers. It uses little "cup" seals that fit over springs recessed in the back of the valve body. The springs press these "seals" against the cartridge and regulate the flow through little tapered openings in the cartridge. If you have one of these and it's dripping, changing these springs and seals will usually correct it. Here's a tip. Once you have the cartridge out of the way, insert a phillips screwdriver into the seal and pop both the seal and spring out. Stick the new ones on the end of the screwdriver to help guide them into place. This is especially helpful if you don't have long slender fingers.
Dirty waste water, after all, leaves your house following the law of gravity. Waste water goes downward to the sewer or septic tank, nice and easy. Behind this simple rule is the multitude of vents and traps to keep the process of waste removal possible. Vents allow air to fill drainpipes, precious air that allow waste water outflow. Traps are those curved S-shaped sections of the pipes under the sink drain. Traps perform a crucial role in forcing most of the water through the drainpipe, but leaving some to seal the area and prevent sewer gas from backing up.
Plumbers, like all other companies, are required to be on time and act professional. If they have called before hand to notify you then, this can be overlooked. However, if they turn up without apologising for being late, then they may not be the right plumber for you. Remember first water line repair impressions are everything. If they lack a good first impression then this may indicate that it is going to have an impression on their work. In most cases, you would have taken the time off work for the plumber, and what can be worse than waiting all day waiting for them to arrive?
And the way to know what's sufficient? Well, until the work is done an the bill paid you won't know for certain, but this is the best that can be suggested and normally works very well.
Be sure to choose a licensed glass shop in your area. There are a lot fly by night shops out there. You pay a lot of money for your vehicles so you want quality work at a fair price. Do the homework before you have this procedure done because proper preparation before installing a windshield will keep your car from having rust issues which may cause water leaks.